DC Audio 3.5K Competition Series Car Audio Mono Amplifier: 5,100 Watt Peak Power

DC Audio 3.5K

Competition Series 3500 watt Monoblock Amplifier

The 3.5kw competition series amplifier is a 3,500 watt mono block. It is capable of running up to 18 volts for up to 5,100 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.

It comes with a bass knob and a clipping indicator. For power inputs it will accept 0 awg for power and 0 awg for ground.

Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator

DC Audio recommends for installation
• 1 upgraded battery under the hood
• 1 extra battery in the rear
• Minimum of one 0 awg ran from the front battery to the rear battery
• Upgraded aftermarket alternator
• Dash mounted voltage meter

Features 

• Output Power (RMS) 
• 4 ohm 14.4V 750Wx1
• 2 ohm 14.4V 1,800w x 1
• 1 ohm 14.4V 3,500Wx1
• 1 ohm 16V 4,000Wx1
• 1 ohm 18V 5,100Wx1
• Input Sensitivity      6V~0.2V 
• Low Pass Filter Switchable 
• ( @ 24 dB Slope) Variable Hz 35~250
• Subsonic Filter Switchable 
• ( @ 24 dB Slope) Variable Hz 10~50
• Bass Boost Variable dB    0-9dB
• Frequency Response Hz    15-270
• Signal to Noise Ratio dB    100
• Efficiency @ 4ohm % Over    90%
• THD @ 4ohms    Less than 0.1%
• Fuse Rating   300 Amps
• Linked Fuse Rating    600 Amps
• Indicator Power    Yes
• Protection    Yes
• Clip    Yes
• Speaker & Power terminal Mold Type
• Power Gauge 0Ga
• Heatsink Length 21.26" (540mm)
• Heatsink Width 9.38" (238mm)
• Heatsink Height 2.35" (59.6mm)